USING THE APPLIANCE FOR THE FIRST TIME
2. USING THE APPLIANCE FOR THE FIRST TIME
After installation remove all notification labels (not gas or electrical warning labels), advertising, tape, packaging,
etc. A quick diluted wash with Ammonia and water should rinse away any adhesive residue. Eucalyptus oil (small
amounts) is also good for removing adhesive residue. Thoroughly rinse cleaned surfaces and wipe them dry using
a clean, soft cloth.
Before using the BBQ grill (CB355 BBQ Grill Model) make sure the volcanic rocks are removed from their
wrapping and place them into the removable grill tray.
Before using the ceramic glass cooktop (ceramic cooktop models only) clean it thoroughly with a suitable cooktop
cleaner (e.g. Hillmark Ceramic Cooktop Cleaner) and rinse with a clean, warm, damp cloth or paper towel. To
avoid cooked on cleaner residue, wipe the glass dry with a soft cloth or paper towel.
NOTE: People with sensitivity to cleaning chemicals must take the necessary precautions. It is recommended that protective
gloves be worn while cleaning the appliance.
2.1 Burning In (CB35 BBQ Grill Model)
Before cooking with the appliance an initial pre-heat is required to burn off the fine oil film used to protect the
elements during shipping. The first time you heat up the elements the oil will be given off as smoke (some smell
may also be noticeable), which is perfectly normal.
Turn the BBQ grill controls to Hi and leave for approximately 10 minutes or until the smoke has disappeared.
After completing the above turn all controls off. The cooktop is now ready for grilling.
6
To Next Page
Loading...
