Stack-On E-48-MG-C-S - Page 3

IMPORTANT
Keep your combination number in a secure place, away from
children. Keep this record of your serial number and
combination number in a secure place separate from your
safe. If you forget or lose the combination number you will
need the serial number as a reference for obtaining a copy of
your combination number.
e shelving can be installed by locating the shelf
clips to the desired locations and seing the shelf
in place.
NOTE: e scope stand-o will function properly
for many combinations of guns with scopes.
Screw the scope stand-o into the pilot hole of the
barrel rest.
INSTALLATION OF SCOPE STAND-OFF
(Select Models only)
DOOR ORGANIZER ACCESSORIES
(Select Models only)
Your door organizer provides a variety of storage
options for your supplies.
Note: Securely aach the pistol holsters to the back
panel before you holster your pistol. Make sure the
door accessories do not interfere with items in the
safe or when closing the safe door.
SECURING THE SAFE
1
Secure the safe with the fasteners and replace the
carpeting.
Use these holes to fasten the safe to the oor. Drill
the appropriate diameter and depth of pilot holes
into the oor depending on the type of hardware
being used and the type of oor surface. (Figure 2)
To secure your safe to the oor it will rst be
necessary to drill pilot holes through the re
insulation in the oor of the safe. First place the safe
in the desired location. Li the boom carpeting up
to nd the two hole locations marked on the oor
insulation. Drill holes through the insulation using
the same diameter drill as the diameter of the
mounting hardware you are using.
IMPORTANT: e fasteners you use must
completely ll the hole you drilled into the
insulation. (Figure 1) You must use the fasteners
aer you drill the holes. Failure to do so will void the
re rating.
2
NOTE: e safe must be secured to the oor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: is safe must be mounted to the oor.
Failure to do so will compromise the safety and
security of the safe.
SHELVES (Select Models only)
40250-2203
3
15