Stack-On PDS-1800-E - User Manual

40791-1802
1
12
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4” (7 mm) Drill Bit
*3/8” (9.5 mm) Masonry Brill Bit for drilling into masonry
*3/16” (5 mm) Drill Bit for drilling into wood and wall studs
* For model PDS-1805-E only
PDS-1800-E Hardware Included:
(2) M6 x 15 mm (5/8” long) Screws
(2) M6 Nylock Nuts
PDS-1805-E Hardware Included:
(4) M6 x 50 mm (2” long) Lag Screws
(4) M6 x 40 mm (1-1/2” long) Plastic Masonry Anchors
(4) M4 x 25 mm (1” long) Screws
(4) Washers
(4) Drywall Anchors
Your Electronic Safe Combination:
Serial #:
Instructions
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: You can store your Key #, Serial #
and Combination on Stack-On’s SECURE
website – stackon.com under Customer
Service. Storing your Key # or Combination
will provide instant access to this important
information should you ever lose your keys or
your combination.
Only you will have access to this information.
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
PDS-1800-E
PDS-1805-E
®
NOTE: The key has also been provided in case
you lose or forget your security code or the
baeries run low. If you lose your key, you
may purchase a replacement key by
referencing the serial number located under
the removable lock cover. See secon at the
end of this instrucon regarding
replacement keys.
Locate the baeries inside the safe. Open the
baery compartment on the back of the door
by pushing the tab in the direcon of the arrow
and install the baeries.
GETTING STARTED
When you first receive your new electronic safe
you will need to open the door with the key in
order to install the baeries. Baeries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver as
shown. Insert the key and turn
counterclockwise. Hold the key in the open
posion and turn the knob to the right to
open the door.
LOCK COVER
Battery Disposal
Please dispose the used batteries
per municipal or provincial law.

Summary

IMPORTANT SAFETY AND OPERATION NOTES

Record Serial Number and Combination

Record serial number from tag on safe or lock cover plate and your combination number.

Secure Storage of Keys and Combination

Store keys and combination securely away from children and not inside the safe.

GETTING STARTED

Initial Safe Setup and Key Operation

Unboxing, battery installation, and opening the safe with the key.

Battery Disposal

ENTERING YOUR SECURITY CODE

Setting Up Your New Security Code

Steps to set a new 3-8 digit security code and confirm it.

Incorrect Code Lockout Procedures

Safe lockout sequence and duration after multiple incorrect code entries.

Combination Storage Recommendation

Record combination securely, away from children, not inside the safe.

INTERNAL LED LIGHT

KEYPAD SOUND CONTROL

BATTERY REPLACEMENT

LOCKING THE SAFE

Locking Procedure and Notes

How to lock the safe by turning the knob and waiting for the mechanism to engage.

SECURING THE SAFE

Drawer Mounting Guide

Steps to mount the safe into a drawer using screws and nuts.

Child Safety Warning

Important safety warning to keep the safe out of children's reach.

SELECTING A LOCATION

WALL MOUNTING (FOR MODEL PDS-1805-E ONLY)

Wall Mounting Instructions

Steps to mount the safe to a wall stud and drywall anchors.

Wall Mount Locking Note

Ensure wall-mounted safe is in an upright position for proper locking.

MAINTENANCE

Door Alignment Adjustment

Instructions to realign the door using an Allen Wrench on the hinge stem.

IMPORTANT KEY;COMBINATION STORAGE

REPLACEMENT KEY OR COMBINATION REQUEST

LIMITED THREE YEAR WARRANTY

Warranty Coverage and Exclusions

Details warranty period, coverage, exclusions, and limitations for steel safes.

Stack-On PDS-1800-E Specifications

General

Weight	85 lbs
Material	Steel
Lock Type	Electronic
Steel Thickness	14-gauge
Mounting	Pre-drilled holes for floor or wall mounting
Battery	4 AA batteries