Stack-On PDS-1500 User Manual

40536-1506
1
18
Your Electronic Safe Combination:
Serial #:
®
Instructions
PDS-1500
PDS-1505
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: You can store your Key #, Serial #
and C
ombination on Stack-On’s SECURE
web site – www.stack-on.com under Service.
Storing your Key # or Combination will provide
instant access to this im
portant information
should you ever lose your keys or your
com
bination.
Only you will have access to this information.
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4” (7 mm) drill bit
*3/8” (9.5 mm) masonry drill bit for drilling into masonry
*3/16” (5 mm) drill bit for drilling into wood and wall studs
* For model PDS-1505 only
Hardware Included:
(4) M6 x 15 mm (5/8” long) Machine Screws
(4) M6 Nylock Nuts
*(4) M6 x 50 mm (2” long) Lag Screws
*(4) M6 x 40 mm (1-1/2” long) Plastic Masonry Anchors
*(4) M4 x 25 mm (1” long) Screws
*(4) Washers
*(4) Drywall anchors
NOTE: is key has also been provided in case
you lose or forget your security code or the
baeries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See section at the end of this instruction
regarding replacement keys.
Locate the baeries inside the safe. Open the
baery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the baeries.
GETTING STARTED
When you rst receive your new electronic safe you
will need to open the door with the key in order to
install the baeries. Baeries are included and are
located inside the safe.
To open the door with the key, rst remove the
lock cover from the front of the faceplate using a
thin bladed athead screwdriver as shown. Insert
the key and turn counterclockwise. Hold the key
in the open position and turn the knob to the
right to open the door.
Lock Cover
NOTE: e reset buon located on the inside
of the door, is covered with a removable cap.
When you use the reset buon while seing
your own combination, remove the cap to
access the buon. Use a pen tip to push the
reset buon.
Replace the cap securely over the reset buon
aer seing your combination. Failure to do
so will compromise the safety and security of
the safe.

Stack-On PDS-1500 Specifications

General

Type	Personal Safe
Lock Type	Electronic Keypad
Material	Steel
Battery Type	4 AA batteries
Color	Black
Fire Rating	Not Fire Rated
Water Resistance	Not waterproof
Mounting	Yes

Summary

GETTING STARTED

Open the door with the key

Procedure to open the safe door using the provided key and a flathead screwdriver.

Install the batteries

Locate and install the correct batteries inside the safe's battery compartment.

Using the reset button

How to access and use the reset button for setting your new combination.

ENTERING YOUR SECURITY CODE

Set your personal security code

Step-by-step guide to entering and confirming your new security code.

Code entry error handling

Explanation of safe lockout procedures for incorrect code entries.

LOCKING THE SAFE

Proper locking procedure

Instructions on how to correctly lock the safe by turning the knob.

BATTERY REPLACEMENT

Battery type and life

Information on the type of batteries required and their expected lifespan.

Battery replacement steps

Procedure for opening the compartment and replacing batteries.

SELECTING A LOCATION

Safe placement guidelines

Recommendations for choosing an optimal, secure, dry, and isolated location.

SECURING THE SAFE

Child safety warning

Critical safety reminder to keep the safe out of reach of children.

TURNING THE KEYPAD SOUND OFF/ON

Keypad beep control

Instructions on how to turn the keypad beep sound on or off.

DRAWER MOUNTING

Drawer installation steps

Procedure for marking, drilling, and securing the safe in a drawer.

WALL MOUNTING

Wall mounting procedure

Steps for securely fastening the safe to a wall stud and using anchors.

MAINTENANCE

Door hinge adjustment

How to adjust door hinges to fix rubbing issues.

LIMITED THREE YEAR WARRANTY STEEL SAFES

Warranty coverage details

Information on product warranty, coverage, and exclusions.