Portable Case
Instructions
CONTROL FEATURES
1. Key lock
2. Red indicator light
3. Green indicator light
4. Combination buttons
5. Reset button (inside case)
6. Battery Compartment (inside case)
Record the serial number from the tag on the front.
Record your combination number.
Keep keys in a secure place away from children.
DO NOT store keys or your combination in the case.
Serial #:
Your Combination #:
GETTING STARTED
When you first receive your case you will need to open the cover with the key in order to install the batteries. Batteries
are included and are located inside the case.
INSTALLING THE BATTERIES
NOTE: The key lock must be in the locked position
before trying to remove the motor compartment to
install the batteries.
Pull the foam liner back and remove the nuts to the
motor compartment. Slide the compartment back
and lift out. Install the (4) AAA akaline batteries as
shown. Reinstall the compartment and the nuts.
CAUTION: Be careful not to pinch any wires while
reinstalling the motor compartment.
NOTE: If the batteries are low the red light will go on
while the case is opening. Replace with 4 new AAA
akaline batteries as shown.
NOTE: This key has also been provided if you lose or forget your security code or the batteries run low. If you lose your key, you
may purchase a replacement key by referencing the serial number located on the front of the case. See section regarding
replacement keys for further information.
To open the case, insert key into lock and turn counterclockwise until the cover automatically opens. NOTE: You must turn the key
back to the locked position before you are able to close and lock the cover.
40263-1110
12
1
7mm
To Next Page
Need help?
General
