40611-1505
1
21
Combination #:
Serial #:
®
Instructions
PWS-1555
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: You can store your Key #, Serial # and
Combination on Stack-On’s SECURE web site
– www.stack-on.com under Customer Service.
Storing your Key # or C
ombination will provide
instant access to this important information
should you ever lose your keys or your
combination.
Only you will have access to this information.
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
10 mm Wrench
3/16” (5 mm) drill bit for drilling into wood and wall studs
Hardware Included:
(6) M6 x 50 mm (2” long) Lag Screws
(6) Washers
(6) M6 x 40 mm (1-1/2” long) Plastic Masonry Anchors
(12) 1/2" screws
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
NOTE: is key has also been provided in case
you lose or forget your security code or the
baeries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See section at the end of this instruction
regarding replacement keys.
Locate the baeries inside the safe. Open the
baery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the baeries.
GETTING STARTED
When you rst receive your new electronic safe you
will need to open the door with the key in order to
install the baeries. Baeries are included and are
located inside the safe.
To open the door with the key, rst remove the
lock cover from the front of the faceplate using a
thin bladed athead screwdriver as shown. Insert
the key and turn counterclockwise. Hold the key
in the open position and turn the knob to the
right to open the door.
Lock Cover
NOTE: e reset buon located on the inside
of the door, is covered with a removable cap.
When you use the reset buon while seing
your own combination, remove the cap to
access the buon. Use a pen tip to push the
reset buon.
Replace the cap securely over the reset buon
aer seing your combination. Failure to do
so will compromise the safety and security of
the safe.
To Next Page
Need help?
General