Stack-On PWS-1555 - Battery, Sound, and Location; Battery Replacement and Sound Control; Location Selection and Safety

40611-1505
3
21
NOTE: Do not mix old and new baeries. Do not
mix alkaline, standard or rechargeable baeries.
is safe uses 4 - AA baeries. Under normal use,
baeries will last about 1 year.
NOTE: If the baeries are low, the yellow light will
ash when you start to enter your code.
To replace the baeries, open the baery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
baeries.
BATTERY REPLACEMENT
SELECTING A LOCATION
TURNING THE KEYPAD SOUND
OFF/ON
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
You can turn o the "Beep" sound of the keypad
by pressing the ... key.
To turn the "Beep" sound on, press the ....
key again.
e safe must be mounted in a wall between two
wall studs, and then secured to the wall studs.
For optimal safety and security, the safe should
be installed in an isolated, dry and secure area.
NOTE: is safe must be mounted in a wall and
then secured to the wall studs. Failure to do so will
compromise the safety and security of the safe.
NOTE ON LOCKING THE SAFE: e safe
needs to be in an upright position, as shown in
gure 1, for the locking mechanism to function
properly. Failure to mount the safe in the
corrrect upright position will compromise the
safety and security of the safe.
SECURING THE SAFE
Figure 1
Your safe comes with the "Beep" sound turned on.