Stack-On PWS-1855-E User Manual

40800-1803
1
14
Combination:
Serial #:
®
PWS-1855-E INSTRUCTIONS
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
NOTE: You can store your Key #, Serial #
and Combination on Stack-On’s SECURE
website – stackon.com under Customer
Service. Storing your Key # or Combination
will provide instant access to this important
information should you ever lose your keys or
your combination.
Only you will have access to this information.
Drill
Thin Bladed Flat Head Screwdriver
10 mm Wrench
3/16” (5mm) Drill Bit
(6) M6 x 50mm (2" long) Lag Screws
(6) Washers
(6) M6 x 40mm (1-1/2" long) Plasc Masonry Anchors
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
NOTE: This key has also been provided in case
you lose or forget your security code or the
baeries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See the secon at the end of these
instrucons regarding replacement keys.
Locate the baeries inside the safe. Open the
baery compartment on the back of the door
by pushing the tab in the direcon of the arrow
and install the baeries.
GETTING STARTED
When you first receive your new electronic safe
you will need to open the door with the key in
order to install the baeries. Baeries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver as
shown. Insert the key and turn Le.
Hold the key in the open posion and turn
the knob to the Right to open the door.
LOCK COVER
NOTE: The reset buon located on the
inside of the door, is covered with a
removable cap. When you use the reset
buon while seng your own combinaon,
remove the cap to access the buon. Use
the p of a ballpoint pen or the end p of a
paper clip to push the reset buon.
Replace the cap securely over the reset
buon aer seng your combinaon.
Failure to do so will compromise the safety
and security of the safe.
Battery Disposal
Please dispose the used batteries per municipal or
provincial law.
HARDWARE INCLUDED:
TOOLS REQUIRED:

Stack-On PWS-1855-E Specifications

General

Brand	Stack-On
Model	PWS-1855-E
Category	Safes
Language	English