Stack-On PWS-1855-E - ENTERING YOUR SECURITY CODE; Setting Your Personal Security Code; Testing and Confirming the Code; Incorrect Code Entry Procedures

40800-1803
2
14
ENTERING YOUR SECURITY CODE
To enter your own security code you will need to
follow the steps listed below:
1. Aer installing the baeries, locate the reset
buon on the back of the door.
2. Press the reset buon with a pen and then
release it, you will hear a beep. DO NOT SHUT
THE DOOR UNTIL YOU HAVE CONFIRMED THAT
YOUR NEW SECURITY CODE HAS BEEN
ENTERED CORRECTLY.
3. With the door open, enter your own personal
security code, which can be 3-8 digits long, and
confirm your new code by pressing the .... key
on the electronic touch pad. You will have
3 seconds to press the .... key otherwise you
will have to start over from step one. There will be
2 beeps (if the sound is turned on) and the green
light will flash 2X if your code has been entered
successfully. Before you close the door, enter the
new security code and press the .... key to
make sure the lock releases the knob so you can
turn it and retract the live acon locking bolts.
If the code fails, go through steps 1-3 again.
If the code works successfully, then you should
lock the safe.
When you open the safe in the future enter the
security code you have set followed by the ....
key and turn the knob.
NOTE: The reset buon located on the
inside of the door, is covered with a
removable cap. When you use the reset
buon while seng your own combinaon,
remove the cap to access the buon. Use a
pen p to push the reset buon.
Replace the cap securely over the reset
buon aer seng your combinaon.
Failure to do so will compromise the safety
and security of the safe.
If an incorrect security code is entered 3 mes
the light will flash red 5X and beep 5X (if the
sound is turned on) then alarm will sound for
10 seconds resulng in the safe being
automacally locked out for 1 Minute before
you can try your code again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
If an incorrect security code is entered
1 addional me the light will flash red 5X and
beep 5X (if the sound is turned on) then alarm
will sound for 30 seconds resulng in the safe
being automacally locked out for 5 minutes
before the code can be tried again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
To close the safe, push the door closed
unl locked.
Write your new combinaon on this instrucon
sheet or store your combinaon on our secure
website at stackon.com under Customer Service.
If you write down your combinaon you must
keep this informaon in a secure place, away
from children, not inside the safe.
INTERNAL LED LIGHT
This safe includes an internal LED light that will
acvate when the correct combinaon is
entered and will remain on for 30 seconds.