Why is my Staco Energy SC60021T UPS battery backup time so short?
If the Staco Energy UPS backup time is shorter than expected, charge the batteries for 8 hours. If the backup time remains insufficient, contact your local distributor to replace the battery.
How to fix a Staco Energy SC60021T with a red fault LED?
If the red fault LED is lit on your Staco Energy UPS, take the following actions: 1. Ensure the battery connection is correct, then recharge the batteries for 8 hours. If the UPS still doesn't back up normally, contact your distributor. 2. Remove any short circuit at the EPO terminal. 3. Clear any obstructions from the ventilation holes. 4. Check that the cooling fans on the rear panel are functioning correctly. 5. Ensure the UPS is operating normally. If it's in CVCF mode, turn it off and on again. 6. Ensure all parameters except ID Numbers are the same in parallel units. 7. Reconnect the RJ-45 wire or set a UPS with ID=1. 8. When the UPS is in CVCF mode, bypass input is prohibited. Turn off the UPS and bypass input and restart the UPS. 9. If the issue persists, consult your loc...
General| Model | SC60021T |
|---|---|
| Type | Line Interactive |
| Input Voltage | 120VAC |
| Output Voltage | 120VAC |
| Output Frequency | 50/60 Hz |
| Phase | Single Phase |
| Topology | Line Interactive |
| Communication Port | USB |
| Battery Recharge Time | 6 hours to 90% capacity |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Humidity | 0% to 95% non-condensing |
| Battery Type | Sealed Lead Acid (SLA) |
To Next Page
