What to do if the Staco Energy UPS is overloaded?
If the Staco Energy UPS is overloaded, you should remove excess loads from the UPS output. If the devices connected to the UPS are fed directly by the electrical network via the Bypass, remove excess loads from the UPS output. If, after repetitive overloads, the UPS is locked in the Bypass mode, first remove excess loads from the UPS output, then shut down the UPS and restart it.
What to do if Staco Energy UPS shows fault code 43?
If fault code 43 is shown, and the icon is lighting on the LCD display, and the alarm is continuously sounding, it means the Staco Energy UPS shut down automatically because of an overload at the UPS output. To resolve this, remove excess loads from the UPS output and restart it.
What to do if Staco Energy UPS displays fault code 14?
If fault code 14 is shown, the icon is lighting on the LCD display, and the alarm is continuously sounding, it means the Staco Energy UPS shut down automatically because a short circuit occurred on the UPS output. You should check the output wiring and if connected devices are in a short circuit status.
How to fix reversed line and neutral conductors in Staco Energy SCV-10001 UPS?
If the icon is flashing and is lighting on the LCD display, and the alarm is sounding every second, it indicates that the line and neutral conductors of the UPS input are reversed. To fix this, rotate the mains power socket by 180° and then connect it to the Staco Energy UPS system.
How to disable EPO function on Staco Energy SCV-10001?
If the icon is flashing and the warning code is lighting on the LCD display, and the alarm is sounding every second, the EPO function is activated. To disable the EPO function, set the circuit in a closed position.
What to do if battery is incorrectly connected in Staco Energy SCV-10001?
If the icon and is flashing on the LCD display and the alarm is sounding every second, it indicates that the external or internal battery is incorrectly connected. Ensure all batteries are properly connected.
Why Staco Energy SCV-10001 UPS battery backup time is shorter than nominal value?
If the Staco Energy UPS battery backup time is shorter than the nominal value, it could be due to the batteries not being fully charged or being defective. Charge the batteries for at least 5 hours and then check the capacity. If the problem persists, consult the manufacturer. Alternatively, the batteries may be defective, in which case you should contact the manufacturer to replace them.
How to troubleshoot no indication and alarm on Staco Energy SCV-10001 UPS?
Check if the input power cord is firmly connected to the mains. Also, ensure that the AC input power cord is correctly plugged into the AC input.
General| Brand | Staco Energy |
|---|---|
| Model | SCV-10001 |
| Category | UPS |
| Language | English |
To Next Page
