5
the CLIP LED illuminates when clipping is detected. If clipping occurs, the volume
level should be reduced.
5. DSP MODE LEDS: One of the LEDs illuminates to indicate which DSP mode is in use.
6. MIC/LINE: Volume control for the MIC/LINE input.
7. LINE/MIC: Button to switch the MIC/LINE input sensitivity between line level and
microphone level.
8. MIC/LINE: Combination 1/4" / XLR input jack for input from a line level source or a
dynamic microphone.
9. GUITAR/MIC: Volume control for the GUITAR/MIC input.
10. GUITAR/MIC IN: 1/4" input jack for input from a guitar or dynamic microphone.
11. AUX/MP3: Volume control for the AUX input or the mp3 player.
12. AUX IN: Unbalanced stereo line input.
13. DSP PRESET: Rotate the knob to select the various DSP modes.
14. MIX OUT: Line level output for connecting another speaker.
15. 115V/230V: Voltage selector switch used to set the input voltage. The switch is
covered by a clear plastic plate to prevent it from being accidentally changed.
16. POWER: Switch for turning the speaker on or off.
17. AC INPUT: Combination IEC 60320 C14 power connector and fuse holder.
BLUETOOTH PAIRING
Perform the following steps to pair your mobile device with the Digital Player.
1. Press the MODE button to select BT mode. If a previously paired device is within
range, the speaker will connect to that device. Otherwise, the speaker will enter
Bluetooth® Pairing Mode.
2. Open the Bluetooth settings on your phone and scan for nearby Bluetooth devices.
3. Locate and select the SRD210 entry. If prompted for a passcode, enter 0000 (four
zeros).
To Next Page
Loading...
