Stages cycling Stages Power

Questions and Answers

C
charlenechangAug 1, 2025
What to do if the power meter signal is not being received for Stages cycling Stages Power?
- A
  Anthony BallAug 1, 2025
  If the power meter signal from your Stages cycling Bicycle Accessories isn't being received, make sure the power meter is successfully paired to the display.
K
Katelyn RiveraAug 5, 2025
What to do if LR Power unit left side battery dies when paired via Bluetooth on Stages cycling Bicycle Accessories?
- A
  Anne RoseAug 5, 2025
  If the left side battery of your Stages cycling Bicycle Accessories LR Power unit dies when paired via Bluetooth, add the right sensor as a new Bluetooth sensor.
T
thomas76Aug 10, 2025
How to fix error codes 1, 2, 4, 16 on Stages cycling Stages Power Bicycle Accessories?
- C
  Colleen HarrisAug 10, 2025
  If you encounter error codes 1, 2, 4, or 16 on your Stages cycling Bicycle Accessories, try zero resetting again. If the code persists after several attempts, please contact technical support.
S
sydneyvalenciaAug 14, 2025
What to do if no power or cadence signal from Stages cycling Stages Power?
- S
  Stacey NguyenAug 14, 2025
  If your compatible display unit isn't receiving power (watts) or cadence (RPM) signals from your Stages cycling Bicycle Accessories, first, make sure a working CR2032 battery is correctly installed in the power meter. Then, pedal with a cadence higher than 20 RPM. Finally, check that the power meter is successfully paired with your display unit.
V
vburnsAug 18, 2025
Why does my Stages cycling Stages Power Bicycle Accessories calibration time out?
- T
  Thomas MitchellAug 18, 2025
  If the calibration process for your Stages cycling Bicycle Accessories times out, especially when using a Garmin® display with the heart rate (HR) sensor enabled, turn off the HR sensor on your Garmin during calibration and turn it back on after the power meter is calibrated. If the issue persists, attempt zero reset again or contact Stages Cycling – Technical Support.
C
Cory PearsonAug 23, 2025
Why am I not receiving power or cadence signals from my Stages cycling Bicycle Accessories?
- B
  Brandon WeaverAug 23, 2025
  If you're not getting any power (watts) or cadence (RPM) signal from your Stages cycling Bicycle Accessories, there are a few potential reasons: 1. **Battery**: Make sure a working CR2032 battery is correctly installed in the power meter. 2. **Pedaling**: Ensure you are pedaling with a cadence greater than 20 RPM. 3. **Pairing**: Verify that the power meter is successfully paired with your display unit, following the manufacturer's instructions.
M
Michael SilvaAug 27, 2025
What to do if error code #32 is displayed on Stages cycling Bicycle Accessories?
- E
  Emily SmithAug 27, 2025
  If you see error code #32 displayed on your Stages cycling Bicycle Accessories, it means the power meter crank is not in the correct position. Ensure the power meter crank is positioned straight down to resolve this issue.