RoHS
compliant
4
USER’S MANUAL
10 GA & 10 GA P
INSTRUCTIONS FOR USE:
Plug the mains lead into a suitable power socket and connect your instrument to the input socket of the
amplier with a suitable guitar lead (this lead is not supplied with the amplier, but is normally supplied
with the electric guitar). Finally, press the Power Switch to the ON position, the power LED will glow and
your amplier is ready for use.
IMPORTANT SAFETY INSTRUCTIONS:
READ AND KEEP THESE INSTRUCTIONS HEED ALL WARNING.
• If, after you have followed the instructions outlined above, your Amplier fails to function, please contact
your local distributor. Under no circumstances remove the rear panel of the Amplier whilst it is connected
to the mains supply.
• Electrical appliances must never be used where there is a danger of water splashing onto the unit.
• Your attention is drawn to the instructions printed on the rear panel of the amplier.
• Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably
to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufciently intense
noise for a prolonged time.
MARKING & CONFORMITY:
1. The CE mark on this product means it conforms to the EMC Directive (89/69/EEC), CE marking Directive
(93/68/EEC) and Low Voltage Directive (72/23/EEC).
2. The «Crossed-out Wheeled Bin» is to drawn your attention on the WEEE (Waste Electric & Electronic
Equipment) Directive (2002/96/EC). It means this apparatus must be collected separately for recycling.
3. «RoHS compliant» means this device conforms to the Directive (2002/95EC) on the restriction of the use
of certain hazardous substances in electrical and electronic equipments, such as: Mercury, Lead, Cadmium,
Hexavalent Chromium, Polybrominated Buphenyl (PBB) and Polybrominated Diphenyl Esthers (PBDE).
USER’S MANUAL
10 GA & 10 GA P
GUITAR AMPLIFIER
DISTRIBUTOR/DEALER
EMD Graphics 04-2006.
To Previous Page
