Stagg TIM JR 516 - Hi-Hat Assembly; Hi-Hat Stand Setup; Pull Rod and Clutch Integration

a. HI-HAT
Top hi-hat x 1
Feet section
Insert the foot pedal rod and tighten.
Open the feet and make sure
all feet are well secured to the ground.
Take out the pull rod from the top-section
tube and leave the clutch aside.
Insert the pull rod and tighten.
Tighten the feet & foot pedal rod.
Top section
Top-section tube
Pull rod
Clutch
Bottom hi-hat x 1
1
3
5
2
4
6
7 8
Insert the top-section tube
and tighten.
Place the bottom hi-hat.