GB
•
erase memory
transmitters
=
to cancel all
the recorded transmitters, enter
the
menu
delete
, then
go to
the wording
erase
memory
transmitters
on
the
display
and press ENTER. The
message
PRG
will appear, it
flashes until
the decision to
cancel all
the recorded
codes is
confirmed
by
pressing
ENTER or
the operation
is
cancelled
by
keeping the same
key
pressed
for longer.
N.B: To
cancel
the
memory
of the
receiver,
it is
neccessary
to
confirm
twice the
cancellation (
erase
memory
transmitters
and
PRG
)
Language
The
display is
available
in two
languages:
italiano
and
english
.
To
select the chosen language
go to
the menu
language
and press ENTER. Go to
italiano
or
english
and
confirm
by
pressing
ENTER.
Lear
ning
This
operation
allows
the automation
to
automatically establish the start
and end
of a
stroke identifying the respective mechanical strokes. Before proceeding
with
this
operation, ensure
that the gate has been
installed
correctly and firmly and
that the
en
function
of
the control
board has
been activated (Stagnoli supplies
the
control
board with
this function
already activated).
When
the wording
setup
appears
on
the
display,
press
ENTER. At
this point
the
motors
will close the gate. They will open it
completely
again and will repeat
this operation once more with the control
board display
showing maximum use
of
the
motors.
Then
set
the regulation
values fm1a and fm1c so
that
they exceed
the
detected values
(if
fm1a
,
fm1c
,
fm2a
and
fm2c
have a low value this indicates
greater anti-crushing
sensitivity).
Should
consumption
be shown to be excessively high, check that there are no
areas
where the
gate has
greater friction.
To do
this, monitor the values
showing
instant
absorbed power by the
motors
during their
stroke
and
presented
in the
second main screen
of
the
display.
If the operation has been carried out
correctly,
the message
OK
will
appear.
If
this has not been carried out correctly, the
message
ERR
will appear.
WARNING: during learning manoeuvres, the control
board will
ignore
START and
PEDESTRIAN
commands
and will work with
the
force
parameters that
have been
set. Even if
the safeties remain
active,
ensure that there
are no
objects
or people
in
the
area of
operation
of
the
gate.
Read code
It
is
possible
to check if a code has already
been memorised. Position yourself
on
the
wording read
code
, press ENTER,
the
display will show
the message
PREMI
(PRESS)
.
Now press
the transmitter
key
that must
be checked, a
series
of screens
describing the
code will be viewed:
•first screen:
S
r
01
or
-
f
01.
The first
letter
indicates the
manufacturer
of the radio
control,
where
S
means
Stagnoli
and
-
a
generic
manufacturer
.
The second letter indicates the type
of code,
where
r
indicates
a
rolling
code and
f a fixed code.
The last
two
indicate the
code of
the
key
that
was pressed.
•second screen:
P_00
, where
P
indicates the word “position” and the
number
that follows
(progressive
from 0 to 75), indicates the position occupied by the
To Next Page
Loading...
