To Next Page
A
Ashley RasmussenAug 18, 2025
What to do if Stahl YA60 Security System cables show signs of aging or damage?
- TTimothy TaylorAug 18, 2025
If you notice that the cables of your Stahl Security System are aged or damaged, you should replace them.
What to do if Stahl YA60 Security System cables show signs of aging or damage?
If you notice that the cables of your Stahl Security System are aged or damaged, you should replace them.
How to fix aged or damaged seals on a Stahl YA60?
If the seals on your Stahl Security System are damaged, aged, or porous, replace them. For enclosure components with foamed seals, replace the entire component.
What to do if the conductors aren't clamped properly in Stahl YA60?
If you find loose conductors in your Stahl Security System, clamp them tightly.
What to do if Stahl YA60 Security System enclosure components have cracks or damage?
If the enclosure components of your Stahl Security System are cracked or damaged, replace the exchangeable components. If the components are non-exchangeable, the device must be taken out of operation.
What to do if Stahl YA60 is not used for its intended purpose?
If your Stahl Security System device is not used according to its intended use, it must be taken out of operation.
What happens if the Stahl YA60 Security System exceeds the permissible ambient temperature?
If the Stahl Security System exceeds the permissible ambient temperature or falls below it, the device must be taken out of operation.
What to do if cables show ageing and damage in Stahl Industrial Equipment?
If you notice the cables are damaged or aged, you should replace them.
What to do if seals show ageing and damage in Stahl Industrial Equipment?
If the seals are damaged, aged, or porous, replace them. For enclosure components with foamed seals, change the entire component.
What to do if conductors are not clamped properly in Stahl Industrial Equipment?
If you find loose conductors, ensure you clamp them tightly.
What to do if the enclosure components have cracks and damage in Stahl Industrial Equipment?
Replace any exchangeable enclosure components. If the damaged enclosure components cannot be exchanged, the device should be taken out of operation.
Details the structure and types of warning notes (DANGER, WARNING, CAUTION, NOTE).
Specifies required qualifications for personnel handling the device.
Covers safe use before installation and for mounting/installation procedures.
Warns against unauthorized modifications and their potential consequences.
Safety warnings for mounting, dismounting, and selecting the operating position.
Details safety measures and procedures for making electrical connections.
Explains how to configure the device using DIP switches on the PCB.
Lists audible settings, frequencies, and special applications based on DIP switch configurations.
Provides a step-by-step guide for mounting the device, including screw and seal notes.
Lists essential checks and conditions required before commissioning the device.
Procedures for troubleshooting and information needed when contacting support.
Guidelines for general maintenance, overhaul, and repair procedures.
General| Category | Security System |
|---|---|
| Operating Temperature | -40 °C to +60 °C |
| Optical Zoom | 30x |
| Video Compression | H.264, H.265, MJPEG |
| Certifications | ATEX, IECEx |
| Enclosure Material | Stainless Steel |
| Ingress Protection | IP68 |
| Image Sensor | 1/2.8" CMOS |
| Resolution | 1920 x 1080 (Full HD) |
| Protocols | TCP/IP, HTTP, HTTPS, RTSP, RTP, UDP, ONVIF |
| Power Supply | 24 VAC / VDC |
| Voltage | 24 VAC / VDC |
