Need help?Do you have a question about the Stairville HL 40 DMX and is the answer not in the manual?
Control other units for synchronized light shows using master/slave setup with dipswitch 10.
Utilize Pocket Master I or Foot Master I for controlling units in master/slave mode via a 1/4" microphone jack.
Address units using dip switches 1-9 to receive DMX signal from a universal DMX controller.
Check power, fuse, lamp, DMX connections, dipswitch settings, and cable integrity for no light or DMX issues.
Verify DMX cabling for breaks and check the red LED for signal response if units don't respond to the controller.
Ensure no DMX signal is active, the unit is not in a specific display mode, and check the microphone functionality.
General| Type | LED Flood Light |
|---|---|
| Power Consumption | 40W |
| Light Source | LED |
| LED Type | RGB |
| Beam Angle | 25° |
| Power Supply | 100-240V AC, 50/60Hz |
| Weight | 2.5 kg |
| Operating Voltage | 100-240V AC |
| Color Mixing | RGB |
| DMX Channels | 7 |
| Control Modes | DMX, Master/Slave, Sound-to-Light |
| Housing Material | Aluminum |
To Next Page
