11
STORAGE AND FOLDING INSTRUCTIONS
STEP 5
Refer to illustration Step 5. Set the position of the SECURE PINS(10) as shown. Lift up the RAILS(1, 2)
and insert the SECURE PINS(10) back into the RAILS(1, 2). Hook the Wire Rings onto the pins from the
bottom of the RAILS(1, 2).
STEP 6
Fold the trampoline again as shown in illustration Step 6.
Wire Ring
STEP 4
To prevent the trampoline from snapping into the folded position, push the four RAILS down. Then unhook
the Wire Ring from the SECURE PINS(10) and turn the pins to a at position to remove the pins. Firmly
grasp both sides of the trampoline and fold the trampoline upward, the trampoline will fold upward at the
BRACKETS as shown in illustration Step 4.
STEP 3
Remove the SAFETY PAD(6) from the frame. After the SAFETY PAD(6) is removed, place the trampoline
on the oor with the threaded connectors pointing up. Refer to illustration Step 3.
Threaded
Connector
Bracket
The safety pad must
be removed before
folding the trampoline.
Wire Ring
STOP! ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
inTONE® REBOUNDER. FAILURE TO USE TWO OR MORE STRONG PEOPLE MAY ALLOW
THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND STRIKE SOMEONE WHICH
CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
Step 3 Step 4
Step 5 Step 6
To Next Page
Loading...