EasyManua.ls Logo

Stamina inTONE Plus - Use Instructions; Using the Resistance Tubes; Using the Fitness Meter

Stamina inTONE Plus
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USE INSTRUCTIONS
12
1. Rechargeable batteries are not recommended.
NOTE:
1. Open the Battery Door on the back of the meter.
2. The meter operates with an AA battery, the battery is not included.
Refer to the illustration to install or replace the batteries.
HOW TO INSTALL AND REPLACE BATTERIES:
Bounce on the trampoline or press any button.
Automatic shut off after four minutes of inactivity.
POWER ON :
POWER OFF :
FUNCTION BUTTONS:
MODE :
RESET :
Press to select the function of the lower readout.
To reset all functions to zero.
TIME:
STRIDES/MIN:
CALORIE:
COUNT :
SCAN:
Displays the workout time from one second up to 99:59 minutes.
Displays the rate of strides per minute.
Displays the calorie consumption from zero to 9999 cal.
The calorie readout is an estimate for an average user. It should be used only as a
comparison between workouts on this unit.
NOTE: The meter will stop counting time automatically after six seconds of inactivity. All function
values will be kept. Restart the meter by bouncing on the trampoline or press any button.
The meter will shut off automatically after four minutes of inactivity. All function values will
be kept. Press the RESET button to reset all functions to zero.
FUNCTIONS:
USING THE FITNESS METER
1.
2.
AA Battery
USING THE RESISTANCE TUBES
1. Use with HAND GRIPS(17) during your workout or while standing stationary on the inTONE® Rebounder.
2. Clip one end of each RESISTANCE TUBE(16) to the STRAP LOOPS(18) located on the legs of either side
of the METER(20) and hook the HAND GRIPS(17) to the other ends of the RESISTANCE TUBES(16).
3. The RESISTANCE TUBES(16) are detachable so they can be used alone without the inTONE®
Rebounder for total body strength training.
NOTE:
Inspect the resistance tubes for nicks and cuts before each use. Replace damaged resistance tubes.
Upper readout displays the total number of strides
you have taken from zero to 9999 strides.
Automatically scans each function of TIME,
CALORIE, STRIDES/MIN in sequence with
change every six seconds.
CNT
TIME
CALSCAN
STRIDES
/MIN
SCAN
D
O
E
M
S
E
E
T
R
Ultimate disposal of battery should be handled according to all
state and federal laws and regulations.

Related product manuals