Need help?Do you have a question about the STAMOS TRON 200 ONE and is the answer not in the manual?
General| Input Voltage | 230 V |
|---|---|
| Duty Cycle | 60% at 200A |
| Open Circuit Voltage | 56 V |
| Welding Current MMA | 10 - 200 A |
| Welding Current TIG | 10 - 200 A |
| Electrode Diameter (MMA) | 1.6 - 4.0 mm |
| Housing Protection | IP21S |
| Insulation Class | F |
| Welding Current Range | 10 - 200 A |
| No-Load Voltage | 56 V |
| Duty Cycle at 200A | 60% |
| Input Frequency | 50/60 Hz |
| Efficiency | 85% |
| Output Current | 200A |
General safety advice for users and qualified personnel, and proper unit operation.
Guidelines for securing areas during fire hazardous welding work and preventing ignition.
Essential PPE for welding to protect against arc radiation, noise, and physical hazards.
Precautions and measures to prevent electric shock hazards during operation.
Hazards associated with gases and fumes during welding and necessary precautions.
Guidelines for intended use, warranty, unit placement, and environmental conditions.
Recommendations for storing the welding unit properly to protect it.
Instructions for electrical and gas connections to the unit.
Identification of components visible on the front panel of the welder.
Identification of rear panel connectors for gas and power.
Steps for connecting cables for various welding methods (MIG/MAG, TIG, MMA).
Procedure for replacing or adjusting the drive roller groove for wire feeding.
Step-by-step guide for loading and replacing the welding wire spool.
Procedures for cleaning, maintenance, and regular inspection of the device.
Guidelines for packaging disposal, transport, and storage.
To Next Page
