Stan-Tech SDN11RH User Manual

SDN11RH
PNEUMATIC STICK NAILER
103248REVB 4/98
OPERATION and MAINTENANCE MANUAL
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL, TO UNDERSTAND
AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE INSTRUCTIONS WITH THE
TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, CONTACT YOUR STAN-TECH
REPRESENTATIVE OR DISTRIBUTOR.

Stan-Tech SDN11RH Specifications

General

Brand	Stan-Tech
Model	SDN11RH
Category	Nail Gun
Language	English

Summary

LIMITED WARRANTY

SAFETY INSTRUCTIONS

AIR SUPPLY AND CONNECTIONS

OPERATING PRESSURE

LOADING TOOL

SDN11RH TOOL SPECIFICATIONS

LUBRICATION

LOADING THE SDN11RH SERIES STICK NAILER

FASTENER DEPTH CONTROL ADJUSTMENT

TOOL OPERATION CHECK

ADDITIONAL SAFETY WARNINGS

MAINTAINING THE PNEUMATIC TOOL

AIR SUPPLY-PRESSURE AND VOLUME

TROUBLE SHOOTING

Trigger valve housing leaks air

Problem: Trigger valve housing leaks air. Cause: O-ring cut or cracked. Correction: Replace O-ring.

Trigger valve stem leaks air

Problem: Trigger valve stem leaks air. Cause: O-ring/seals cut or cracked. Correction: Replace trigger valve assembly.

Frame/nose leaks air

Problem: Frame/nose leaks air. Cause: O-ring or Gasket is cut or cracked. Correction: Replace O-ring or gasket.

Frame/cap leaks air

Problem: Frame/cap leaks air. Cause: Damaged gasket or seal. Correction: Replace gasket or seal.

Failure to cycle

Problem: Tool failure to cycle. Cause: Air supply restriction. Correction: Check air supply equipment.

Lack of power; slow to cycle

Problem: Lack of power or slow cycling. Cause: Tool dry, lack of lubrication. Correction: Use Approved Air Tool Lubricant.

Skipping fasteners; intermittent feed

Problem: Skipping fasteners or intermittent feed. Cause: Worn bumper. Correction: Replace bumper.

Fasteners jam in tool

Skipping fasteners; intermittent feed (2)

Fasteners jam in tool/canister