Need help?Do you have a question about the Standard C8800 and is the answer not in the manual?
General| Brand | Standard |
|---|---|
| Model | C8800 |
| Category | Transceiver |
| Language | English |
Covers installation, power supply, and antenna precautions for the transceiver.
Highlights microcomputer-aided operations and various selectable channels.
Details memory back-up, channel selection, microphone controls, and panel design.
Lists additional features like receiver booster, call frequencies, signal meter, and speaker.
Describes the front and rear panel controls and indicators of the transceiver.
Provides a detailed breakdown of each front panel control and its function.
Describes the rear panel connectors and switches.
Provides instructions for setting up the transceiver as a fixed or mobile station.
Details antenna installation and power supply for fixed station setup.
Provides instructions for installing the transceiver in a mobile environment.
Explains the advanced operational features controlled by the microcomputer.
Provides precautions for using radio waves and adhering to local regulations.
Details microcomputer operations like scanning intervals and power/back-up settings.
Guides on how to properly receive signals using the transceiver.
Provides instructions for transmitting signals with the transceiver.
Explains how to determine the correct crystal frequency for Repeater-3 mode.
Details the pin configuration for accessory terminals and remote control.
Explains the procedure to reset the microcomputer in case of malfunction.
Explains the functional blocks of the transceiver.
Explains the receiver section's design, sensitivity, and signal processing.
Details the transmitter section's functions, including APC and modulation.
Describes the Phase-Locked Loop (PLL) section for frequency control.
Outlines the components of the controller section, including microcomputer and display.
Provides common symptoms, causes, and remedies for troubleshooting.
Guides on performing PLL adjustments, including conditions and jigs.
Details power adjustments for the younger booster and power protector.
Details IF and RF adjustments for optimizing receiver performance.
Explains how to adjust chip switches for frequency display.
Shows the detailed wiring connections for the transmitter section.
Presents the wiring diagram for the PLL section of the transceiver.
Presents the wiring diagram for the RX section of the transceiver.
Details parts related to the escutcheon assembly and front panel.
Details parts related to the chassis, covers, and internal structural components.
Details parts associated with the heat-sink assembly and related components.
Lists various internal boards and common parts used in the transceiver.
Lists electrical components such as capacitors, resistors, and semiconductors.
Lists capacitors used on the PLL board (P101).
Lists resistors used on the PLL board (P101).
Lists semiconductors used on the PLL board (P101).
Lists general specifications like frequency band, emission type, and dimensions.
Details receiver system, IF frequencies, and sensitivity specifications.
Lists transmitter specifications including power, impedance, and response.
To Next Page
