Standard S3 - User Manual

To Next Page

IMPORTANT: READ ALL INSTRUCTIONS BEFORE THE INSTALLATION.

CAUTION

An internal power-factor-corrected switch-made supply allows this luminaire to be used from any nominal

100-277 V & 277-480 V, 50/60 Hz AC supply without any variation in light output.

NOTE: SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

WARNING

Risk of re or electric shock. The installation should be performed only by a qualied electrician in accordance

with the National Electrical Code and relevant local codes. This product must be installed in full accordance

with applicable electrical and building codes. This xture is for outdoor use and should not be used in areas with

limited ventilation or high ambient temperatures.

WARNING - TO AVOID ELECTRIC SHOCK

• Be certain electrical power is OFF before and during installation and maintenance.

• Luminaire must be connected to a wiring system with an equipment-grounding conductor.

WARNING - TO AVOID EXPLOSION

• Make sure the supply voltage is the same as the rated luminaire voltage.

• Do not install where marked operating temperatures exceed the ignition temperature

of the hazardous atmosphere.

• Do not operate in ambient temperatures above those indicated on the luminaire.

• Keep lens tightly closed when in operation.

• For supply connections use wire rated for at least 90°C.

400 W Mounting Options

Installation Instructions

LED Outdoor Large Flood Light S3

400 W

Need help?

Do you have a question about the Standard S3 and is the answer not in the manual?

Summary

Ensure power is OFF before installation/maintenance and connect to an equipment-grounding conductor.

Match supply voltage, avoid extreme temperatures, keep lens closed, and use wire rated for at least 90°C.

Instructions for adjusting fixture orientation, mounting to a 2.36" post, and wiring connections.

Instructions for securing the fixture with expansion bolts and making wiring connections.

General