W3 – Manual
WAM8W3A 7 Standby AB – standbygroup.se
Maintenance
Note
Use a mild car wash shampoo and a sponge that is gentle/appropriate to the lightbar surface
as well as the vehicle surface.
CAUTION
When using high-pressure cleaner:
Water pressure at a maximum of 80 bar.
Minimum distance of 80 cm between the gun and the lightbar.
Direct the gun so that the spray pattern hits the surface at a 90° angle.
Always thoroughly rinse with clean water after a high-pressure wash.
Follow the steps above to avoid negative impacts on packing seal, logos and decals.
Caution
Do not use degreaser.
Caution
Machine wash with brushes is acceptable, as long as the brushes are clean. However this will
increase the risk of the plastic becoming matte and scratchy.
To Previous Page
Loading...
