OPERATING INSTRUCTIONS
Unpacking
Carefully unpack your air compressor. This air compressor is bulky and
heavy, two (2) person lift required. Dispose of all packing material in an
environmentally responsible manner.
Assembly
Your air compressor requires minor assembly before initial operation. Check
that you have all required components required for assembly and initial use.
Your compressor is filled with oil do not tip to assemble.
Oil Breather:
To fit the oil breather:
1. Remove the transport plug and throw away, see Pic. 2.
2. Screw in the oil breather, see Pic. 2.
Lubrication:
Warning: Your air compressor IS FILLED with OIL!
To check the oil level:
1. Always check the oil level when the air compressor is on flat and
level ground.
2. To confirm the oil level lift the back, wheel end, up about 20cm, hold
for about 1 minute and place back on ground.
Look at the sight glass and ensure the oil is above the red dot on the sight
glass, as per the “OIL LEVEL GAUGE” label, see Pic. 3 and Pic. 4.
To add oil, if required, additional oil not included:
1. Remove oil breather.
2. Add oil, SAE30 to at least the top of the red dot, see Pic. 4.
3. Oil level will take about 1 minute to drain down and settle.
4. Check oil level in sight glass, see Pic. 3. Re-check and top up if required,
until level is correct.
WARNING
Do not attempt to operate this compressor until it is fully
assembled.
Damage caused due to incomplete assembly will not be covered
under warranty.
Ensure the air compressor is disconnected from the power supply
before carrying out any assembly, maintenance or adjustments
on the machine.
Never under fill or over fill with oil.
PIC. 2
Screw in oil
breather
Remove
and discard
transport plug
PIC. 3
Oil level should be to
the top of the red dot
on the sight glass
as per the label
PIC. 4
To Next Page
Loading...
