PIC. 8
AIR FILTER
The supplied air filter must be used.
Failure to do so may result in irreparable damage and will void the
warranty, Pic. 8
To install:
1. Carefully screw supplied air filter into the threaded hole on the top
of the pump head. This only needs to be done up by hand. Do not
use tools to tighten air filter.
NOTE: Do not OVER TIGHTEN as this may damage the air filter or
cylinder head which will NOT be covered under warranty.
STARTING AND STOPPING YOUR AIR
COMPRESSOR
Pic. 9
NOTE: Always ensure that you plug your air compressor into a standard
240V AC power point. Never use an extension cord as this can lead to
a voltage drop which may cause power loss and over heating. Use a
longer air hose if you need to get closer to your work area.
Always start and stop the compressor using the ON/OFF button
on the Pressure Switch (Pic. 1 Item 1 and 14 as well as Pic. 9).
Damage caused by not using this button will not be covered by
warranty.
To turn your air compressor ON;
Lift up the red ON / OFF button on top of the pressure switch
To turn your air compressor OFF;
Push down the red ON / OFF button on top of the pressure switch
PIC. 9
Push button
down for off
Lift button
up for on
To Next Page
Loading...
