PIC. 14
DRAIN TAP
Pic. 14
After use open the drain tap to drain excess air and any moisture. The
excess air will also help purge the moisture. Leave the drain tap open
when air compressor is not in use, so any moisture can continue to drain
To open the drain tap pull the lever down to vertical.
To seal the drain tap push the lever up to horizontal.
NOTE: Remember to seal the drain tap before starting the compressor.
PIC. 13
AIR TAP
Pic. 13
The air tap will need to be opened to allow the air to flow to the attached
air tool.
To open air tap rotate the handle so that it lines up with the fittings and
hose, not supplied.
To close air tap rotate the handle so that it is at 90º to the fittings and
hose, not supplied.
NOTE! This air compressor has a maximum pressure of 10BAR
(145PSI), always regulate the air pressure to match your air tool.
Different air tools require different operating pressures. Always
check with the tool manufacturer if unsure.
Closed tap
Drain Tap Sealed
Open tap
Rotate tap handle to open/close start/stop the air
supply to your attached tool
OR
To close and seal push lever up Right or left
To open and drain pull lever down
Drain tap opened un-sealed
To Next Page
Loading...
