Stanley AC6359 - Page 11

10 11
PIC. 5
PIC. 6
PIC. 7
RUBBER STOPPER
To attach the rubber stoppers to the bracket located on the bottom of
the tank;
1. Undo and remove the nut and star washer.
2. Push through the bracket and replace the star washer and nut.
3. Tighten the nut, Pic. 5.
WHEELS
1. Undo and remove the nut and star washer.
2. Push bolt through wheel bracket and replace the star washer.
3. Tighten the nut, Pic. 6.
Use 3 hex head screws to
attach handles - 2 on this
side and 1 on other side.
HANDLE
1. Position handle under and inside the Motor/Pump
deck at the motor end.
2. Line up holes.
3. Secure with the three hex head screws, Pic. 7.