12 13
PIC. 8
AIR FILTER
Air filter is factory fitted.
To replace filter:
1. Carefully unscrew the screws inside the air filter.
2. Remove air filter.
3. Replace with new air filter.
4. Replace and tighten the screws to secure the
air filter . Do not over tighten the screws.
NOTE: Do not OVER TIGHTEN as this may damage the air filter or
cylinder head which will NOT be covered under warranty.
STARTING AND STOPPING
YOUR AIR COMPRESSOR
Pic. 9
NOTE: Always ensure that you plug your air compressor into a
standard 240V AC power point. Never use an extension cord as this
can lead to a voltage drop which may cause power loss and over
heating. Use a longer air hose if you need to get closer to your work
area.
Always start and stop the compressor using the
ON/OFF button on the Pressure Switch (Pic. 1 Item 2 and 3 as
well as Pic. 9). Damage caused by not using this switch will not
be covered by warranty.
To turn your air compressor ON;
Lift up the red ON / OFF button on top of the
pressure switch
To turn your air compressor OFF;
Push down the red ON / OFF button on top of the pressure switch
PIC. 9
Push button
down for off
Lift button
down for on
To Next Page
Loading...
