12 13
RUNNING IN YOUR NEW
AIR COMPRESSOR
Before running in ensure that the following has been
completed:
1. Oil level is correct, see page 10.
2. The air compressor has been fully assembled, see pages 10 – 12.
Your new air compressor requires running in:
1. Plug the power cord into a standard
240V AC power point.
2. Open the tank drain tap.
3. Start the air compressor using the
ON / OFF button.
4. Run the air compressor for approximately
1 minute.
This ensures that the air compressor is fully lubricated under no load.
After the 1 minute stop the air compressor using the
ON / OFF button. Allow to cool approximately 10 minutes. Recheck the
oil level and top up if needed, additional oil, SAE30, not included.
Before starting your air compressor again ensure that
the tank drain tap is closed.
USING THE AIR COMPRESSOR
Before starting, run through this simple list:
1. Oil level – CORRECT (top of red dot).
Please refer to diagram, Pic. 4, page 10.
2. Drain tap – open and drain tank.
3. Drain tap – close fully.
4. Check power lead for any damage. If damaged have replaced by
an authorised service centre.
5. Plug air compressor into a standard 240V 10Amp
AC power point and turn ON.
6. Lift the air compressor button to turn ON,
see page 12, Pic. 9.
7. Allow the air compressor to fill the air tank.
8. Turn the power point OFF and disconnect the power lead from the
power point.
9. Connect your air hose and air tools.
10. Reconnect to the power lead to the power point and turn ON.
11. Turn your air compressor ON.
12. Set the outlet air pressure to match your air tools requirement.
13. Once turned and you begin using the connected air tools the
air compressor will start and stop without warning. This is
controlled by the pressure switch. These pressure settings are
factory set and should not be changed.
Pumping starts at (minimum) 115PSI and stops at (maximum) 145PSI.
Once the initial pump up stage has finished you can adjust the outlet
air pressure to the tools recommended working pressure and open
the air tap fully.
To Next Page
Loading...
