1. The display should alternate between OFF2 and the
time of day currently set.
2. Adjust using + or - to set the time the second event is
to end,
3. Press SET once to confirm.
4. Again, if this is not required set the time to 00:00 and
then press SET.
1. To repeat the event of the previous day, press the
REPEAT button once.
2. To repeat the second event of the previous day, press
the REPEAT button once.
3. Alternatively, to set different times from the previous
day, alter the required time.
1. To set individual days, press SET once.
2. Adjust to the day required using + or - buttons.
3. Press SET to confirm the day chosen.
4. Adjust to the new times required as before.
5. Again, if an event is not needed set to 00:00.
6. Once day is set (both events), display should fault to
time of day.
1. Press the TIMER button once.
2. 00:00 should be displayed.
3. Adjust to the time required using + or - buttons.
4. Press TIMER to confirm.
5. Press TIMER to show the time of day. To check the
remaining time on the minute minder, press TIMER
once then press TIMER again to show the time of day.
Once the timer has finished, it will flash 00:00 and a
buzzer will sound. To stop press TIMER.
To return to MANUAL mode at any time whilst
programming press the AUTO/MAN button and time of
day will be displayed.
10
REPEATING DAYS
Fig. 11
DESN 516002
SETTING THE PROGRAMMER - DAILY
Fig. 12
DESN 516003
SETTING THE MINUTE MINDER
Fig. 13
DESN 516004
To Next Page
Loading...
