User Manual
GB
Plumb Transfer
•
reference plane.
• Position the desired object(s) until they are aligned
with the vertical reference plane to ensure object(s)
are plumb.
Level Transfer
• Using the horizontal laser beam, establish
• Position the desired object(s) until they are aligned
with the horizontal reference plane to ensure
object(s) are level.
Square
• Using the vertical and horizontal laser beams,
• Position the desired object(s) until they are aligned
with both the vertical and horizontal laser beams to
ensure objects(s) are square.
WARNING:
Read all safety warnings and instructions
included in the accompanying Safety
Instructions and User Manuals before using
this product. Failure to follow the warnings and
for the instrument must ensure that all users
understand and adhere to these instructions.
• Prevent unintentional start up. Ensure the switch
is in the off-position before picking up or carrying
on the switch or energizing the unit with the
switch in the on position invites accidents.
• The laser should only be recharged with the
power supply provided by connecting it to
the DC power supply jack shown in Figure
A#4
for one type of product or battery pack may
product or battery pack.
• The laser comes with an integrated and
rechargeable Li-Ion battery pack which is not
user replaceable or serviceable. Do not attempt
to install any other battery packs as this may
• When device is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that
another. Shorting the battery terminals together
supply jack is closed with the attached rubber
plug when not in use.
• Under abusive conditions, liquid may be ejected
from the integrated batteries; avoid contact. If
liquid contacts eyes, additionally seek medical
help. Liquid ejected from the batteries may cause
irritation or burns.
•
product may exhibit unpredictable behavior
•
explosion. See recommended temperatures in
• The laser product is not user serviceable and
should be returned to your distributor or Stanley
or damage. Any service applicable should be
only identical replacement parts. This will ensure
that the safety of the product is maintained.
To Next Page
Loading...
