EasyManua.ls Logo

Stanley FMC640 FatMAX - Troubleshooting and Tool Care; Troubleshooting Common Issues; Battery Notes and Tool Cleaning

Stanley FMC640 FatMAX
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
c
an be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This Class B
digital apparatus complies with Canadian ICES-003.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
Unit will not start. Battery pack not installed Check battery pack
properly. installation.
Battery pack not charged. Check battery pack
charging requirements.
Battery pack will not Battery pack not inserted into Insert battery pack into
charge. charger. charger until LED appears.
Charger not plugged in. Plug charger into a working outlet.
Refer to “Important Charging
Notes” for more details.
Surrounding air temperature Move charger and battery pack
too hot or too cold. to a surrounding air temperature of
above 40 degrees F (4,5°C) or
below 105 degrees F (+40,5°C).
SPECIAL NOTES FOR USE WITH LITHIUM BATTERIES
Unit shuts off Battery pack has reached its Allow battery pack to cool
abruptly. maximum thermal limit. down.
Out of charge. ( To Place on charger and
maximize the life of the allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
For assistance with your product, visit our website at www.stanleytools.com for a list of
service centers, or call the Stanley FatMax Customer Care Center at (800) 262 2161.
THE RBRC™ SEAL
The RBRC (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Stanley FatMax.
RBRC in cooperation with Stanley FatMax and other battery users, has established
programs in the United States to facilitate the collection of spent lithium-ion batteries.
Help protect our environment and conserve natural resources by returning the spent
lithium-ion battery to an authorized Stanley FatMax service center or to your local retailer
for recycling. You may also contact your local recycling center for information on where to
drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
MAINTENANCE
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air. Wear safety
glasses when performing this procedure. Exterior plastic parts may be cleaned with a
damp cloth and mild detergent. Although these parts are highly solvent resistant,
NEVER use solvents.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
11

Related product manuals