Stanley IntelliSensor Pro - Operating Instructions; Battery Replacement; Calibration Process

Operating Instructions
Battery Replacement
Open the battei7 door on back
of unit and connect a 9-volt
battery (not included) to clip. ^
Place battery back into case
and snap battery door on.
Recommend to replace a new 9
volt battery when low battery gattery Door
indicator is on. illustration 4
Calibration
Calibrate the unit on wall before
scanning for wood or metal stud.
Note: While calibrating, the
IntelliSensor^'^ Pro must not be placed
directly over a stud, dense material such
as metal, wet or newly painted areas as
this will prevent the unit from calibrating
properly. If this is done over a wood or
metal stud the unit will give no indication
when moved away from the area. Move
to a different location and try again.
Calibrating
Hold the IntelliSensor™ Pro flat against the
surface, making firm contact. Press and
hold the "ON" button. All indicators on the
LCD are displayed while the unit goes
through its 1 to 3 second calibration cycle.
The word "CALIBRATING" will appear on
the LCD (illustration 2) while the unit is
calibrating to surface. Following the
completion of calibration the unit will
beep, and the word "READY" will be
5