17
4.3 Operating on a slope
1.
contact with the ground when
Adjust climbing wheels to avoid
climber running on flat ground or
as shown position in the picture.
2. Tilt machine back and keep
the balance.
3. Operator is located towards
the top of machine with slope
relative to
climbing down
motion. Heavier materials and
larger inclines may require an
additional operator for further
support.
4. Operator is located at the top
of the machine with the slope
relative to climbing
upwards.
Note: Be sure to turn off the power switch during slope operation to
jolting.
To Next Page
Loading...