EasyManua.ls Logo

Stanley ST125T-KFA-E - User Manual

Stanley ST125T-KFA-E
65 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ST-45-KFA-E / ST-70T-KFA-E /ST-70TW-KFA-E /
ST-125T-KFA-E / ST-175T-KFA-E / ST-215T-KFA-E
NEVER LEAVE HEATER UNATTENDED WHILE BURNING, OR WHILE
CONNECTED TO A POWER SOURCE.
THIS PRODUCT IS NOT SUITABLE FOR PRIMARY HEATING PURPOSES.
STKB-430

Table of Contents

Other manuals for Stanley ST125T-KFA-E

Preview: User Manual
User Manual12 pages
Preview: Operating Instructions
Operating Instructions89 pages
Preview: Instruction Manual
Instruction Manual85 pages
Preview: Quick Start Guide
Quick Start Guide4 pages

Questions and Answers

  • S
    Shelby SweeneySep 10, 2025
    What to do if Stanley ST125T-KFA-E won't turn on?
    • H
      Heather ReedSep 10, 2025
      If your Stanley Heater doesn't turn on and the lamp isn't lit, the temperature limit sensor may have overheated; turn the power switch off and let the heater cool for 10 minutes before turning it back on. Check the power cord and extension cord to ensure a proper connection and test the power supply. Also, the fuse might be blown, so check and replace it if necessary. Inspect all electrical connections between the Temperature Limit Sensor and the Circuit Board.
  • W
    Wendy MoranSep 12, 2025
    Why Stanley ST125T-KFA-E Heater fan is not working?
    • A
      Ashley NealSep 12, 2025
      If the fan on your Stanley Heater isn't working when plugged in and the power switch is on, with the lamp flickering or the LED showing 'E1' or 'E2', the thermostat might be set too low (except for model ST-45-KFA-E); rotate the thermostat to a higher setting. Also, there could be a broken electrical connection between the Main PCB and the motor; inspect all electrical connections.
  • M
    Mary WilliamsSep 14, 2025
    What to do if Stanley ST125T-KFA-E lamp flickers and shows E3?
    • M
      michellericeSep 14, 2025
      If the lamp on your Stanley Heater is flickering and the LED display shows 'E3', it indicates that the thermostat switch has failed and needs to be replaced.
  • A
    adamsmichaelSep 16, 2025
    How to fix Stanley ST125T-KFA-E when lamp flickers and shows “E3”?
    • T
      Tonya KellerSep 16, 2025
      If the lamp is flickering and the LED display shows “E3” on your Stanley Heater, it means that the thermostat switch has failed. Replace the thermostat switch.

Stanley ST125T-KFA-E Specifications

General IconGeneral
Voltage120V
BTU4265 BTU
Power1250W
Adjustable ThermostatYes
Overheat ProtectionYes
Cool Touch ExteriorNo
Fan AssistedYes
OscillationNo
Remote ControlNo
TimerNo
Wattage1250 W

Related product manuals