Stanley STHT77502-1 - Page 11

11
GB
Installing AA Batteries
STHT77592-1 laser.
1.
2.
On the bottom of the laser, lift up the latch to
(Figure
B 1
).
3.
batteries, making sure to position the - and +
compartment (Figure
B 2
).
4.
it snaps in place (Figure
B 3
).
When
(Figure A 2 .
Turning the Laser On
1.
,
º position).
2.
beams. Either:
•
left
the cross beams in manual mode
(Figure
A 1
).
• Move the to the
right
cross beams in self-leveling mode
(Figure A 3
).
3.
(Figure
A 4
a horizontal line and a vertical line.
4.
Check the laser beams.
• If the laser is tilted so much that it cannot self-
level (> 4°), or the laser is not level in manual
• the laser is not level
(or plumb) and should NOT BE USED for
repositioning the laser on a level surface.
5.
a project.
• This is the first time you are using the laser
temperatures).
• The laser has not been checked for accuracy
in a while.
• dropped.
Checking Laser Accuracy
It is
check (in
• closest
to the operating distance
the laser.
•
that is level in both directions.
• Mark the center of the laser beam.
Level Beam Accuracy
Checking the horizontal scan calibration of the laser
to conduct a calibration check using a distance no
1.
D 1
).
2.
Move the
right (Figure
A 3
) to turn the laser ON in
vertical beams.