24
6. Operation
Start the brush cutter-grass trimmer-pruner-hedge cutter combination device Start the petrol-
brush cutter-trimmer-pruner-combination device only if an
accessory equipment is connected! Test the corresponding transport protection
and inspect the device for a good operating condition. Never use a damaged, poorly adjusted or
badly maintained or not completely and safely mounted device.
Set the operating switch (3) in On-position "I".
Set the choke lever (24) in the " " position.
5.8 Fuel
ATTENTION: Turn the device off, let it
cool down and pull out the spark plug
connector before you fill up with fuel.
Use only a mixture of lead-free normal petrol and special
2-cycle engine oil in the mixture ratio of 40:1.
Caution: Do not use a different mixing ratio and not a
pure gasoline. Do not use fuel that is older than 2 to 3
months.
For longer work breaks, drain the tank and refill before
starting work.
Mix petrol
Provide fuel and suitable 2-stroke engine oil in the ratio
of 40:1 in the mixing tank (30), e.g. 10 ml of oil to 400 ml
A14
petrol. Seal the container and mix petrol
and oil by vigorous shaking.
Fill petrol
- Unscrew the lid of the tank (7) slowly so that pressure
and petrol vapours escape safely.
- Fill the fuel mixture at best with a funnel and screw the
cap back on again tightly.
A15
6.
To Next Page
Loading...