Stanley STR-4 IN 1 - Fault and Troubleshooting

46
11. Fault and troubleshooting
Fault Possible cause Troubleshooting
The engine does not
start
-
air filter it is dirty
-
Fuel filter clogged
-
Lack of fuel supply
-
Error in the fuel line
-
Starting device is defective
-
Engine flooded
-
Spark plug not inserted
-
No ignition spark
-
Motor defective
-
Carburettor defective
-
Clean/replace air filter
-
Clean or replace the fuel filter
-
Refuelling.
-
Check fuel line for bends or damage
-
Contact the service centre.
-
Remove, clean and dry the ignition
spark plug;
Subsequently pull the starter rope several
times; re-install the ignition spark plug
-
Check the ignition spark plug connector
for correct setting
-
Clean or replace ignition spark plug
-
Check the ignition cable for damage
-
Contact the service centre
-
Contact the service centre
Engine starts and d
ies - Incorrect carburettor setting (Idle speed) - Contact Service Center
Motor starts. H
owever
the cutting tool stops
- Cutting tool is blocked
-Internal error (Drive shaft, transmission)
-Clutch defective
-
Turn off the engine and
remove the object
-
Contact the service centre
-
Contact the service centre
Device works
with interruptions
(compression)
-
The carburettor is set incorrectly
-
Spark plug is sooted
-
On/Off switch defective
-
Contact the service centre
-
Clean or replace the spark plug
-
Contact the service centre
Smoke emission
-
Incorrect fuel mixture
-
The carburettor is set incorrectly
-Use two-stroke mixture in the mixing
ratio 40:1
- Contact Service Centre
Device does not work
with
full power
-
The machine is overloaded
-
The air filter is dirty
-
The carburettor is set incorrectly
-
Silencer blocked
-While mowing/trimming do not press
with force.
-
Clean or replace air filter
-
Contact the service centre
-
Check the exhaust
The brush cutter works
not with full power
-
Cutting blade is blunt or damaged
-
Silage too high (device
overload)
-
Sharpen the cutting blade or get it
replaced
-
Cut grass gradually
G
B