Star Trac Spinner Pro - Page 7

Page 7 SPINNER
®
OWNER’S GUIDE
5. Install the Handlebar
A.
Insert the handlebar post into the
frame assembly and secure in place
using a tension handle.
B.
Position the handlebar on top of the
handlebar post and secure in place
using a tension handle and washer.
NOTE: Tighten the tension handles
firmly.
Step 5A Step5B
6. Install the Water Bottle
Holders
Using the Allen Wrench, remove the
two screws from the right side fork of
the frame assembly. Position a water
bottle holder in place against the
frame assembly, and re-install the two
screws to secure.
Repeat to install the left-side water
bottle holder.
Step 6
You have now completed the assembly of your SPINNER
®
V.
!Attention! Crank bolt must be re-torqued after the first 10 hours of use. Refer to Preventive Maintenance section page 27.