149
Frame
Sand, pebbles, objects on the highway, climate (salt air exposure) or ice inhibiting chemicals
used during the winter months will damage the paint, inviting rust and other deterioration.
Periodically inspect the exterior exposed areas, clean and repaint the frame members occa-
sionally and whenever you notice rust or paint chipped away, to insure protection.
E-Z Lube or Super-Lube Axle (if so equipped)
The E-Z lube or Super-lube feature on your axles provides the ability for the bearings to be
periodically lubricated without removing the hubs from the axle. This feature consists of
axle spindles that have been specially drilled and tted with grease zerks in their ends. When
grease is pumped into the zerk, it is channeled to the inner bearing and then ows back to
the outer bearing and eventually back out the grease cap hole. If you have further questions,
consult with your dealer.
The convenient lubrication provisions of the E-Z lube or
Super-lube feature must not replace periodic inspection and mainte-
nance of the bearings. Use a hand-operated grease gun; improper
use of a commercial grease gun may damage the seals.
in one direction. After polishing, ush the compound from the surface and apply a coat of
wax to regain a beautiful luster.
To prevent corrosion, touch up small cracks and scratches in the paint coat as soon as pos-
sible with touch-up lm or paint. Carefully check the body areas facing the road and the
tires for damage to the paint coat caused by ying stones, etc. Use the closest automotive
paint (available locally) match possible when touch-up paint is needed.
Use a sponge or chamois to clean plastic parts. Use warm water and a soft cloth or chamois
to remove any white residue from dark colored plastic surfaces. Do not use a scrubbing
brush, other hard tools, or wax containing abrasives as they may damage the plastic surface.
To prevent chrome parts from spotting or corroding, wash with water, dry thoroughly, and
apply a non-abrasive automotive wax. If the chrome is severely damaged or pitted, use a
commercially available chrome polish product.
Do not allow plastic to come into contact with brake uid, engine oil, grease,
paint thinner, or battery acid. These will damage plastic. Use a soft cloth and
a mild detergent solution to wipe away any such contact.
Exterior Roof and Sidewall Vents
Inspect the roof vents, including sealants for cracks and keep them clean. Inspect the refrig-
erator and holding tank vents for blockages from bird nests, spider webs, leaves, etc. All
exterior access doors and vents need to be kept clean and free of obstructions (i.e., insect
nests, mud daubers, etc.) while the appliances are in use.
To Next Page
Loading...
