StarFive VisionFive 2 - 1.2. Specifications


Figure 2-2 Connect LED to the 40-Pin Header
2.3. Preparing Soware

Note:
VisionFive.gpio
 Flashing OS to a Micro-SD Card VisionFive 2
Single Board Computer Quick Start Guide
 Using
SSH over Ethernet Using a USB to Serial Converter VisionFive 2 Single Board Computer Quick Start
Guide
 Extend Paron VisionFive 2 Single Board Computer Quick Start
Guide
 
apt-get install python3-pip
 pip VisionFive.gpio 
sudo pip install VisionFive.gpio

sudo pip3 install VisionFive.gpio
 

Tip:

sudo apt-get install python3-dev
sudo python setup.py install




StarFive