StarFive VisionFive 2 - Figure 4-9 Boot Mode Settings

To Previous Page













Main Page

Table of Contents5
List of Tables6
List of Figures7
Features and Specifications8
Features8
Hardware8
Interfaces9
Software10
Specifications10
Hardware Overview13
Board Appearance13
Figure 2-1 Board Appearance (Top View)13
Figure 2-2 Board Appearance (Bottom View)13
Pinout Diagram15
Figure 2-4 Pinout Diagram15
Getting Started17
Required Hardware17
Figure 3-1 Npths on Visionfive 217
Figure 3-2 Single Head Hexagonal Copper Columns18
Figure 3-3 Double Way Hexagon Copper Studs18
Figure 3-4 SSD Mounting Location18
Connecting a Fan to Visionfive 219
Flashing os to a Micro-SD Card19
Flashing with Linux or Windows19
Figure 3-5 Connecting a Fan to Visionfive 219
Logging into Debian20
Figure 3-6 Install Balenaetcher20
Using Xfce Desktop over HDMI21
Using SSH over Ethernet22
Figure 3-7 Debian Interface22
Figure 3-8 Example Output23
Using a USB to Serial Converter24
Figure 3-9 Example Output24
Figure 3-10 Connecting Jumper Wire25
Figure 3-11 Example26
Figure 3-12 Example Configuration27
Figure 3-13 Example Output27
Figure 3-14 Connecting Jumper Wires28
Figure 3-15 Example Output28
Figure 3-16 Example Output29
Figure 3-17 Example Output29
Appendix30
Extend Partition on SD Card or Emmc30
Enable SSH Root Login32
Updating SPL and U-Boot33
Updating SPL and U-Boot of Flash33
Updating SPL and U-Boot of SD Card and Emmc35
Recovering the Bootloader35
Figure 4-1 Connecting to the Debug Pins of Visionfive 2 40-Pin GPIO Header36
Figure 4-2 Boot Mode Setting (UART)36
Figure 4-3 Example Output37
Figure 4-5 Example Output38
Figure 4-7 Example Output39
Github Repository40
Boot Mode Settings41
Figure 4-9 Boot Mode Settings42

StarFive VisionFive 2 - Figure 4-9 Boot Mode Settings

Table of Contents

Other manuals for StarFive VisionFive 2