OPERATION
6
OPERATING THE HOSE REEL
1. Slowly pull the hose reel to desired length. A ratcheting mehanism inside the reel makes a short series of
clicking sounfs every revolution of the reel.
2. To lock the real into postion, listen for the clicking sounds as the hose is slowlyy oulled from the reel. When
the reel clicks, stop pulling the hose. Decrease tension on the hose and the reel will lock into postion.
3. To retract the hose onto the reel, slowly pull out hose until you hear a series of clicking sounds stop. (1/8
revolution). DO NOT LET OF THE HOSE. Allow the hose to retract slowly until the hose stopper rests against
the hose guide.
4. Periodically check the hose for excessive wear and hose connection for leaks.
MAINTAINING THE HOSE REEL
Refer to the parts diagram for part numbers
1. Disconnect the air supply and puul abut 2 feet of hose and latch the reel.
2. Remove the hose stopper.
3. While rmly holding onto the edge of the reel drum, unlatch the reel and carefully allow the drum to slowly
rewind drawing hose end back through the guide arm roller assembly abd onto the reel. Latch reel into position.
4. To increase tension: Unlatch the reel and turn clockwise, as viewed from the air inlet side. To decrease
tension: Unlatch and allow reel to rotate slowly counterclockwise, as viewed from the air inlet side.
5. Once the desired spring tension is reached, latch the reel into postion. Feed the hose end through the roller
assembly in the guide aem and reattach the hose stopper.
6. Connect the incoming air supply.
REPLACING AIR INLET VALVE O-RINGS
Refer to the parts diagram for part numbers.
1. Disconnect incoming air supply and inlet-end of hose from brass air inlet valve.
2. Unscrew air inlet valve assembly (6A & 6B) from axle shaft (13) by tting wrench onto hex portion of the valve
and turning counterclockwise.
3. Remove retaining ring (31) and slide air inlet valve swivel collar (6B) o from air inlet valve body (6A)
4. Remove worn O-rings (2pcs) and replace with new parts.
5. Reverse above procedure to reassemble.
ASSEMBLY
To Next Page
Loading...
Need help?
General
