Starline E9 - Function Engine starting preheater

short user manual
27
connection method:
• rst variant (*):
• deactivate system security;
• hold the brake pedal for 3 seconds;
• the LED on the service button will go out, after which
movement can be started (the START/STOP button need not
be pressed);
• second variant (*):
• deactivate system security;
• press the START/STOP button 1 or 2 times (*);
• the LED on the service button will go out, after which
movement can be started.
(*) Ask the installation specialist during mounting about the
connection method of your system and the operation
algorithm.
Function «Engine starting preheater»
The function allows for engine preheating before starting. The starting
preheater can be controlled both in the manual and automatic mode.
Manual mode
In the manual mode the starting preheater is switched on/o by a
command.
The starting preheater can be switched on by successive pressing of
remote key buttons
12
.
Time of preheater operation in this mode is 20 minutes.
ATTENTION! If the starting preheater has normal settings,
diering from those set in the personal account, operation
time may dier from the specied one.
Operation can be prolonged by sending a repeated command for
starting preheater switch-on.