20
The driver authentication and control with
smartphone via Bluetooth Smart protocol
is available on iPhone with iOS 9 and above
(not for tabs). Not available for Android in
current Bluetooth hardware version.
7) Registration mode is switched o automatically
in 5 min or at ignition On.
8) Exit from the device registration mode will be
conrmed by SMS message with the number of
registered devices.
Registration of StarLine R6 wireless relay unit:
1. Switch ignition O.
2. Disconnect BAT, OUTPUT and INPUT R6 wires
from vehicle circuits.
3. Switch M66 to Registration mode.
4. Interconnect R6 OUTPUT and INPUT wires.
5. Apply input power (connect BAT to +12V and
GND to «-»).
6. Successful registration will be conrmed in 10 sec.
7. Disconnect BAT from +12V and disconnect
OUTPUT and INPUT wires.
8. Make connections according to wiring diagram
and check R6 operation.
To Next Page
Loading...
