Each SPARMAX airbrush is test sprayed and fully inspected to ensure its quality and performance.
Warranted for TWO years from date of factory dispatch against workmanship or material defect
resulting in inoperable airbrush. Exclude parts subject to wear such as needles, nozzles, o-rings,
and damage or loss caused by improper use, unauthorized alteration and negligence.
For any questions or issues, contact the original seller or contact us at info@sparmaxair.com.
WARRANTY
1. Spidering:
1) Paint too thin -> add paint.
2) Pressure too high -> reduce pressure.
3) Too much paint -> pull back push button less or move airbrush further away from surface.
2. Intermittent spray:
1) Clog within airbrush -> clean airbrush thoroughly.
2) Paint too thick -> thin paint with proper thinner.
3) Pressure too low -> increase pressure.
3. Bubbles in cup:
1) Nozzle cap loose -> tighten nozzle cap.
2) Nozzle damaged -> replace with new nozzle.
4. Paint doesn’t spray:
1) Clogged nozzle -> clean nozzle.
2) Paint too thick -> thin paint with proper thinner.
3) Needle chucking nut loose -> tighten needle chucking nut.
4) Pressure too low -> increase pressure.
TROUBLE SHOOTING
To Next Page
Loading...