Start italiana XMT-SI-RF

Need help?

Do you have a question about the Start italiana XMT-SI-RF and is the answer not in the manual?

Summary

INTRODUCTION

GENERAL WARNINGS

Safety instructions for installation, usage, manufacturer disclaimers, personnel requirements, and hazards of explosion and fire.

GENERAL INFORMATION

TECHNICAL CHARACTERISTICS XMT-SI

WIRING OF THE CONNECTOR

Provides wiring diagrams for M12-4 pins and 7/8-4 pins connectors for probe connection.

PRODUCT LABEL DETAILS

MECHANICAL INSTALLATION GUIDE

RF PROBE RISER PREPARATION

ELECTRICAL CONNECTION PROCEDURES

JUMPER SETTING CONFIGURATION

MODEL XMT-SI-RF OPERATION

RF DIP-SWITCH PROGRAMMATION

Describes how to configure RF probe operation modes using DIP-Switches and their impact on battery life.

MODEL XMT-SI-485 CONFIGURATION

485 DIP-SWITCH PROGRAMMATION

Details how to set the unique address for the XMT-SI-485 probe using DIP-Switches.

TRANSMISSION PROTOCOL SPECS

Lists transmission parameters like speed, parity, data bits, and stop bits for XMT-SI-485, LOG, and TTL probes.

XMT-SI-485-LOG DATA LOGGER

DATA LOGGER PROTOCOL COMMANDS

Outlines commands for reading and deleting logger data, with example replies and field interpretations.

POST-INSTALLATION OPERATIONS

PRODUCT APPLICATIONS

SERVICE STATION USE CASE

Provides an illustration of the probe's application and installation scenario at a typical service station.

DEPOT APPLICATION SCENARIO

Shows an example of the probe's use in a depot environment, highlighting different tank configurations.