To Next PageTo Next PageWhy does Start Shaphon Control System return to main window after machining program is started?
If the Start Shaphon Control System returns to the main window after the machining program is started, check the program.
How to fix failure to save the program or clobber in Start Shaphon SH-2012AH-QG Control Systems?
To resolve a failure to save the program or clobber on the Start Shaphon Control System, especially after replacing batteries, press G, G, and 3 in the system's main window successively to format the program area.
Why can Start Shaphon Control System only machine straight lines and not circles?
If the Start Shaphon Control System can only machine a straight line and fails to machine a circle, initialize the system parameters. If the problem persists, check the program or return it to the manufacturer for diagnosis.
What to do if Start Shaphon Control System has a blank screen?
If the Start Shaphon Control System screen is blank, make readjustments. Also, ensure that all connections are secure.
Why is there no system output from my Start Shaphon Control System?
If there is no system output from the Start Shaphon Control System, check and replace the switching power supply unit. Also, try replugging or replacing the relays.
General| Brand | Start Shaphon |
|---|---|
| Model | SH-2012AH-QG |
| Category | Control Systems |
| Language | English |
Details the primary functions and capabilities of the CNC cutting system, including its application areas.
Outlines the hardware and software specifications of the CNC cutting machine, such as processor, display, and I/O.
Details the interface and information displayed in the automatic mode window for CNC cutting operations.
Explains how to adjust the machining speed using multiplying factors in automatic mode.
Details how to select functions like SECTION, MAN, RESBREK, and VIEW within AUTO mode.
Guides on starting speed mode, manual speed, and automatic machining operations.
Explains how to control and adjust the cutting torch position in automatic mode.
Details the steps for returning the cutting torch along the original path after failure.
Explains the procedure for restoring the system to a saved breakpoint.
Details how to start machining from a specific section or piercing point.
Details G-code commands for reference point setting and coordinate modes.
Explains M-codes for program suspension, end, and control of auxiliary functions.
Provides a general overview of parameter categories like speed, system, and cutting parameters.
Guides on accessing and navigating the parameter setting submenus.
Details settings for starting speed, adjustment time, and maximum speed limits.
Explains settings for gear ratio, origins, backlash, and limit switches.
Details specific parameters for flame cutting operations, including delays and timing.
Outlines parameters for plasma cutting, including arc ignition and piercing delays.
Covers settings for mode selection, speed limits, and hole options.
Details parameters for adjusting height controller sensitivity, speed, and position.
Lists and describes the signals and pin assignments for input/output ports.
Illustrates typical wiring connections for flame cutting operations.
Illustrates typical wiring connections for plasma arc cutting operations.
